Ender 3 Pro Turtle LCD Display Case

**THIS PRINT IS FOR THE ENDER 3 PRO ONLY**

ENDER 3 Pro Turtle Upgrade

Although this is technically a remix of
https://www.thingiverse.com/thing:3348552
Mauimauer's design does does NOT fit the Ender 3 Pro.

I made this LCD Display in order to fit the Ender 3 Pro. The back plate is equipped with a SD Card holder that fits snugly but you must remove it from the manufactures case and insert it tail first.
I have also included a back plate without the SD Card slot.
The LCD Display is at a 45 degree angle and offset 40mm from the aluminum extrusion.

The Knob is from,
https://www.thingiverse.com/thing:3123377
But any knob should work.

All of the parts should be printed with an infill greater than 30%
for rigidity. See below for full print settings.

Printing orientations are shown in the images.

-------------HARDWARE REQUIRED------------
x4 M3 x 0.5 mm Thread, 20 mm Long Screws
x4 M3 x 0.5 mm Thread, 3mm High Nuts