Ender 3 Pro Wire Pathway

Designed this to make sure no excessive wear came to the wires that pass through the aluminum extrusion frame on the Ender 3 and Pro.

Once the access panel for the main board is removed (3 bolts on the bottom one on the top) there is a nylon sleeve that all the wires run through minus the display wire.

Carefully cut the nylon sleeve in a straight line as you will use this to line the inside of the pathway covering the PLA to help with protection and minor movement.

Carefully snip any zip ties that may restrict the reorganization of the wires.

Line the inside of the new pla pathway with the nylon and some trimming my be needed.

Place all the wires back into the pathway (including the display wire unless you have it routed differently).

Place a zip tie on both ends of the wires just on either side of the pathway to keep the wires together and help with placing the panel back on.

Replace the main board panel making sure all wires are clear of the movement of