Ender 3 PSU Support

Ender 3 PSU is holding in place by two screws only, over the time the screws may got stressed. This little support that put on the top of the 40x40 extrude and underneath the PSU will help with the situation.

Installation:

BE VERY CAREFULLY remove the end cap(make sure do it very slowly otherwise you might break the tender post that fits into the extrude slot - I break mine, but it is not big deal though), then slide the piece along the extrude and put under the PSU - if you find it is too tight, you can file a little.




If you like my design, please consider supporting me via buy me a coffee link