Ender 3 Rail Clip

I was using Akou91's cable clips for a while but then I ran a camera and some other things so I needed something more.

This isn't actually a remix (in the sense that I did not just open up the original STL and modify it) but I did base the design heavily on Auou91's clips so it only felt right to make it a remix.

This clip is extended on both ends to cover the trenches on the rails. That allows you to tuck cables away into the trenches and have the clip hold them in. The original cable groove is still there so you can run something else there as well (such as a USB camera or ethernet cable to a Pi).

If that isn't enough for you, there is also a tunnel to which you can secure 2.5mm zip ties.

Enjoy.