Ender 3 Raspberry Pi Drawer

WARNING: TIGHT TOLERANCES A simple drawer i made for in my ender 3/pro/v2. I replaced it for my V2 drawer. Drawer can hold:1x Raspberry pi, installed in a sliding carriage2x LM2596 buck converter1x Relay (dont know exact size/serial number)1x 40mm fan on front, can be installed with m3 self tapping screws but hot glue is recommended (must shave off a corner) It has a small gap in the back to allow for cable passthrough, i cut off the small tab on the bottom of the printer to allow cable passthough.Pictures of printed parts and installed in my printer will be uploaded soon. Assembly Guide:Install the raspberry pi on the slider-case, not sure which models fit on it, i used a raspberry pi 3b+ (i used m3 self tapping screws)install all the smaller components (relay/buck converter) (tip: solder the wires first, it might be hard to reach some terminals after installing) ( also used m3 self tapping screws)slide pi in the case from the front, usually the friction fit is good enough to keep it