Ender 3 S1 Cable Guide

This is a remix of Ender 3 S1 CableGuide.

This clamp holds the ribbon cable in place close to the printer just above where it exits the base. It bolts to the Z-axis frame using a bolt and nut provided in the spare parts that should have come with your printer. Optionally add a M5 washer for in between the bolt and the clamp, but I suppose without would work too.

This remix shrinks the size of the original clamp while increasing the hold on the ribbon cable.

I added a loop around the cable so it would be less likely to fold towards the printing bed.
I shrunk the height/width (depending how you look at it) by half because this was not as necessary with the new design.

This is a fast and easy print.

Designed with Autodesk Fusion 360. Sliced with Cura. Printed with Ender 3 S1.
I used PLA+, but any solid material will probably work.
100% infill for sturdiness, but you can probably get away with less.
I did not use support and the hole turned out fine, although I did have