Thingiverse
Ender 3 S1 Pro Cable Bracket Holder
von The-Real-Maker
31
Downloads
56
Likes
0
Makes
In my opinion, the bottom cable of the Ender 3 S1 pro stuck out too far.
This is a bracket that makes the lower cable point inwards.
I use an M4 t-slot nut... works well.
This is a bracket that makes the lower cable point inwards.
I use an M4 t-slot nut... works well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!