Ender 3 Scraper Hilt (Flat Stand)

This is designed as a replacement hilt cap for the factory scraper that comes with the Ender 3. It has a large, flat butt surface that is easier for tapping on when removing sticky prints from the bed, and doubles as a nice little stand.

I find that with the coated glass bed for the Ender 3, the adhesion is so good that I often need to use the scraper to just get under the edge and lift the part to remove it. Once the scraper is positioned on the corner of the part, a light tap can often dislodge it... but the rounded hilt of the stock scraper is wreaking havoc on my soft knuckles.

With this flat hilt/stand, storing the scraper on its end is very convenient, but it also puts the sharp end up. That might be a disaster-waiting-to-happen for some of us. I've also smoothed and sharpened the edge of my scraper to get under those edges a bit easier, so it's an ideal scenario for removing forearm flesh. Thus, necessitating a storage guard.

You can have add a storage guard combined w