Thingiverse
Ender 3 Spool Holder Bracket v2
von EasyT2022
1
Downloads
0
Likes
0
Makes
This is an updated filament spool holder bracket for the side spool arm below:
https://www.thingiverse.com/thing:4904382
The screw hole on arm at the above link will need to be drilled out slightly to accommodate the 3d printed pin on this model.
The bracket screw hole has been modified with a larger diameter hole and a 3d printed pin. The purpose being so that additional hardware is not needed for assembly.
https://www.thingiverse.com/thing:4904382
The screw hole on arm at the above link will need to be drilled out slightly to accommodate the 3d printed pin on this model.
The bracket screw hole has been modified with a larger diameter hole and a 3d printed pin. The purpose being so that additional hardware is not needed for assembly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
