Thingiverse
Ender 3 spool holder extension
di jipjip
1
Download
1
Likes
0
Makes
I have some spools that are wider than the default spool holder for the ender 3.
Most extenders I've found were meant to be screwed to the holder, which would not work for my version.
Therefor I made one that could be inserted into the original. It gives you an extra of minimal 2.5 cm.
I forgot to adjust my infill settings, so it accidentally printed with 0% infill. Works fine.
Support Overhang Angle was set to 70, so there was just enough support to get the smaller part of the piece of the floor. Less may work too.
Most extenders I've found were meant to be screwed to the holder, which would not work for my version.
Therefor I made one that could be inserted into the original. It gives you an extra of minimal 2.5 cm.
I forgot to adjust my infill settings, so it accidentally printed with 0% infill. Works fine.
Support Overhang Angle was set to 70, so there was just enough support to get the smaller part of the piece of the floor. Less may work too.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
