Thingiverse
Ender 3 TFT35-E3 Mount
von DavidETurner
63
Downloads
31
Likes
0
Makes
UPDATE 27/1/2020: Enlarged USB opening on Back Case
Right side mount for Bigtreetech TFT35-E3 v3.0 dual-mode controller. You can have a traditional 12864 emulated LCD controller, or use the touchscreen, and switch back and forth whenever you want. This board has the same form factor as the stock controller, but you can't use the reset button if you just swap it out, unless you want to drill a hole in the stock bracket. The top of the reset button is flush with the face of the case, so you might need something to push it with, if the need arises (I find a hex wrench works well).
Right side mount for Bigtreetech TFT35-E3 v3.0 dual-mode controller. You can have a traditional 12864 emulated LCD controller, or use the touchscreen, and switch back and forth whenever you want. This board has the same form factor as the stock controller, but you can't use the reset button if you just swap it out, unless you want to drill a hole in the stock bracket. The top of the reset button is flush with the face of the case, so you might need something to push it with, if the need arises (I find a hex wrench works well).
DavidETurner veröffentlicht auch auf
13 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
