Thingiverse
Ender-3 Tool Holder
von zugzug21
38
Downloads
18
Likes
0
Makes
Remixed a few things on this tool holder:
1) Increased the width to hold a larger scraper (58mm). See below for link to scraper I use.
2) Reduced the height of the entire holder by 4mm. The original I remixed from was too long to fit without propping the printer higher.
3) Narrowed the clipper holder for a tighter fit
4) Added a holder for my USB microSD adapter
Note: I started with the original clip for the scraper because the remix had some gaps between the clipper holder and the scraper holder that didn't make sense.
Scraper: https://www.harborfreight.com/2-in-high-carbon-steel-multi-tool-flexible-scraper-blade-61824.html
1) Increased the width to hold a larger scraper (58mm). See below for link to scraper I use.
2) Reduced the height of the entire holder by 4mm. The original I remixed from was too long to fit without propping the printer higher.
3) Narrowed the clipper holder for a tighter fit
4) Added a holder for my USB microSD adapter
Note: I started with the original clip for the scraper because the remix had some gaps between the clipper holder and the scraper holder that didn't make sense.
Scraper: https://www.harborfreight.com/2-in-high-carbon-steel-multi-tool-flexible-scraper-blade-61824.html
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
