Thingiverse
Ender 3 V2 Control Knob
von Xz0t1k
16
Downloads
10
Likes
0
Makes
Printed on an Ender 3 V2
This is a remixed design of the knob created by Moussafam12, designed with just just a few polygons more to give it its own style. Make sure to use a brim since bed adhesion isn't the best for something this size. Your time will not slow down as much on lower layer heights so why not go all the way to 0.12mm.
This is a remixed design of the knob created by Moussafam12, designed with just just a few polygons more to give it its own style. Make sure to use a brim since bed adhesion isn't the best for something this size. Your time will not slow down as much on lower layer heights so why not go all the way to 0.12mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
