Ender 3 V2 Control Screen Base

This is remix of the Ender 3 V2 screen stand by BG6211616, which let's you put the control screen of the V2 where it works for you. It was one of the first things I printed, because having the control panel on the left works much better for my setup.

After using it for a couple months, however, there are a few things that bothered me. It wasn't stable enough for me and kept wanting to top over and the angle made it hard to see what was selected on the screen.

While inspired by BG6211616's design, I designed this from scratch in TinkerCAD. These updated make this thing work better for me. Hopefully others will hopefully find useful as well.
- This remix is slightly wider than the control screen, which provides greater stability..
- I increased the angle to 45 degrees, so it's easier to read the screen.
- There are spots on the bottom to attach silicon / rubber feet to keep it from sliding around.
- I added cutouts to the sides to reduce the amount of filament needed to prin