Ender 3 V2 Direct Drive Conversion Mount

Print with ABS or any temperature resistant material as the extruder motor temperatures can go upto 90 to 95 degree C.
You may find holes a little smaller for metal tube piece to fit that is on the screw between roller and carriage plate. This is intensional so the printed bracket do not wobble during printing. Drill/Ream the holes with a 8mm drill bit, drill slowly so plastic will not melt during drilling. the cylindrical tube should fit holes perfectly, fit should not be loose or too tight.
Keep infill 80+ to ensure full strength.
Do note that it requires wire of extruder motor to be extended so be prepared before mounting. Extending cable does not necessary, you can cut wire, join extra cable in between and solder those.