Ender 3 V2 Drawer

#Update

- I have tested and finishing touches have been done this is now fully working 4 x m3*18 screws required to hold all together and 4 x m3*8 screws to hold rpi down(see bottom of page for link to buy the screw set). i have also added 2 gcodes ready to print for pla if your not sure the settings(Note these are set with bltouch autoleveling)
- I have added new files for the updated version its currently untested so if your feeling brave you can go for it I currently have a lot of prints lined up but when there's space I will print it but all looks ok. If you do print the updated version with (untested) and it all goes well could you upload your make or post in the comments to help out thanks :) hope you like it.
- There is now an adjusted screen size for a better finishing look,
- different handle fixed,
- more ventilation and looks nicer,
- access from the bottom now which is held on by the top screws so you can just prop the machine up if you need to adjust anything,
-