Thingiverse
Ender 3 v2 NEO Adjustable Camera Mount
von Ben_Garv
30
Downloads
29
Likes
0
Makes
This is a moving camera mount for ender 3v2 neo.
I created this to add a wifi camera to my setup to monitor prints.
Print this in a lower layer height to make sure the quality it there for it to slot together.
The end of the pin did break off for me but it still works and holds it together.
This has printed perfectly for me and works 100% as it was intended.
It mounts to the printer with the two screws already in it!
I created this to add a wifi camera to my setup to monitor prints.
Print this in a lower layer height to make sure the quality it there for it to slot together.
The end of the pin did break off for me but it still works and holds it together.
This has printed perfectly for me and works 100% as it was intended.
It mounts to the printer with the two screws already in it!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
