Thingiverse
Ender 3 V2 Side Stand
von 3d4LeyeF
889
Downloads
435
Likes
4
Makes
#Purpose
Support the Ender 3 V2 Printer on its side for easy, stable access to the underside of the printer.
#Description
The Ender 3 V2 control board is mounted a upside down from the previous Ender 3's, so it is accessed by removing the bottom panel of the surrounding shell.as opposed to the top panel on previous Enders. This makes for a harrowing balancing act when tilting the printer onto its side to access the correct panel. Because of all the protrusions from the printer, there's almost no stable way for the printer to rest on a surface other than on its feet, making access to the control board very limited.
This side stand design solves this problem by allow the printer to be tiled on its right side to a stable position without removing the screen or any other parts. These can be mounted on the left side also if the filament is mounted to a side mount.
#Design
There are two different legs/feet types in this design. Both can be printed without supports.
## Upp
Support the Ender 3 V2 Printer on its side for easy, stable access to the underside of the printer.
#Description
The Ender 3 V2 control board is mounted a upside down from the previous Ender 3's, so it is accessed by removing the bottom panel of the surrounding shell.as opposed to the top panel on previous Enders. This makes for a harrowing balancing act when tilting the printer onto its side to access the correct panel. Because of all the protrusions from the printer, there's almost no stable way for the printer to rest on a surface other than on its feet, making access to the control board very limited.
This side stand design solves this problem by allow the printer to be tiled on its right side to a stable position without removing the screen or any other parts. These can be mounted on the left side also if the filament is mounted to a side mount.
#Design
There are two different legs/feet types in this design. Both can be printed without supports.
## Upp
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!