Ender 3 Webcam mount (short)

This is a remix of the Ender 3 Webcam mount arm by aallensd (https://www.thingiverse.com/thing:3147743).

My IP camera is larger than most (an old Foscam 9821p), and it was ultimately too high when I mounted it. So I cut a section of the arm out so that the camera would be at a lower level.

I also rotated both pieces so that they load up in the slicer correctly.

Update: I haven't tried it yet, but I updated the infill to be 100%. The camera I use is sagging a little due to weight, so 100% infill might be better. Give it a try.