Ender 3 X Gantry Camera Mount

This is a remix of the Wyze Cam Gantry Mount for the Ender 3.

With this remix, I had the following goals in mind:

1. I wanted to position my Wyze Cam v2 base at an angle. This is necessary to avoid a tilted image on the camera when you pan and tilt the camera down to face the print bed.
2. I wanted to be able to use the same mount with other cameras that support a 3/8in tripod screw. Wyze Cams can still use this mount with the provided magnetic washer and double-sided tape, which allows the camera to be rotated freely.
3. I wanted to simplify the print by reducing the need for supports, so I eliminated the top bubble. This also creates an unobstructed path for the camera cable to be ran with sticky cable clips
4. I wanted to fix a fitting issue I encountered with the original model where it was too small to fit over the motor housing without cracking.