Thingiverse
Ender 3 y axis linear rail mount
von jaccs
19
Downloads
14
Likes
0
Makes
this linear rail mount is for mgn9 rails and uses the original screws and belt.
print without support, the two bigger holes have sacrificial layers so you dont need the support. print two of the spacers and press them into the bottom.
the setup is going to be 2mm higher than stock
print without support, the two bigger holes have sacrificial layers so you dont need the support. print two of the spacers and press them into the bottom.
the setup is going to be 2mm higher than stock
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!