Thingiverse
Ender 3v2 Bed Level Test Print
von MoltenBytes
45
Downloads
32
Likes
0
Makes
Just another test bed-level print for the Ender 3v2. It's only 1 layer thick, and should work with any filament.
As usual, the goal is that each "line" be touching / melted into the next one (not too high), without running thin in the center (not too low).
I also use this to test bed adhesion / temperatures.
As usual, the goal is that each "line" be touching / melted into the next one (not too high), without running thin in the center (not too low).
I also use this to test bed adhesion / temperatures.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!