Ender 3v2 Shroud

Upgraded printer to Spider V3 and discovered stock shroud didn't fit as stated. Made this to replace it. Hanger friction fits over the back plate. Magnets go in holes in hanger and back of shroud. Shroud indexed at top to locate on top of hanger. Magnets on back of shroud hold in place (make sure you match polarities of magnets!)

Fits Ender 3v2 with BLTouch and Spider v3 (should fit any of the Creality hotends)

The magnets I used aren't listed at Amzn any more, but there are many alternatives. I used neodymium magnets I already had on hand. Need 10mm and 6mm.

I'm only using magnets in the top 2 right 10mm and bottom 6mm positions.

2 40mm fans so the stock fans are fine.