Ender-3X Drawer

I had originally grabbed the [Ender 3 Pro Drawer](https://www.thingiverse.com/thing:3265162) by [Reese9885](https://www.thingiverse.com/Reese9885/about) and found that it didn't fit inside of the gap between the display board and the Y-gantry on the Ender-3x. So I increased its size. This drawer is 11 mm wider and will fit snugly in next to the display board. Note that it did require a bit of loosening of the bolts on the side of the printer to get it to fit inside, but once it was in, it was in.

You can either remove the two bolts on the right side underneath the power supply or remove the display board mount and y-belt to slide it in.

Alternatively, just remix this to make it a tiny bit thinner and it will slide right in, no doubt.