Thingiverse
Ender 5 BL-Touch-Bracket plus cable relief V3
por weingran
1
Descargas
0
Likes
0
Makes
This is an Accessory for the Ender 5:
A mounting bracket for the BL-touch sensor AND a cable relief for all the cables to the printing head.
The assembly is a bit tricky, but no extra screws are required. (you need two screws for the BL-touch, if they were not in the package.)
Just unscrew the two screws holding the housing of the printer head and use them later to screw the device and the housing to the printer head.
enjoy
A mounting bracket for the BL-touch sensor AND a cable relief for all the cables to the printing head.
The assembly is a bit tricky, but no extra screws are required. (you need two screws for the BL-touch, if they were not in the package.)
Just unscrew the two screws holding the housing of the printer head and use them later to screw the device and the housing to the printer head.
enjoy
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
