Thingiverse
Ender 5 bottom holder positioner
par BTA_Garage
1
Téléchargements
0
Likes
0
Makes
Ever had a problem when printer moved and you had layer shift because it crashed in enclosure or a wall? I DID!
It was a pain to figure what went wrong.
So designed this holder to screw on your enclosure or table top.
Just use standard wooden screws 3mm diameter. I used 2x12mm wood screws.
See where your printer must be and screw them down and never worry about a walking printer again!
It was a pain to figure what went wrong.
So designed this holder to screw on your enclosure or table top.
Just use standard wooden screws 3mm diameter. I used 2x12mm wood screws.
See where your printer must be and screw them down and never worry about a walking printer again!
BTA_Garage publie également sur
2 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
