Ender 5 Electronics Case Extension

This is an extension for the stock Ender 5 Electronics enclosure to allow installation of upgraded boards such as the SKR 1.3.

I wasn't happy with any of the other designs out there, so I came up with these to allow you to install an upgraded board without too much fuss. This also allows you to retain the factory board cooling fan and location.

I designed these to be used with the Ender 5 Rear Mount Electronics & Power Bracket:
https://www.thingiverse.com/thing:3830464

I also used the Ender 5 - SKR 1.3 adapter here:
https://www.thingiverse.com/thing:3981935

You will need 4 M3x20 to screw these in place.

With this bracket, you will need to cut out some of the existing vent holes to allow access to the USB and SDCard slot.

I also had to use a longer LCD Ribbon to connect the stock display. The Bottom Left corner bracket has a cutout to allow the ribbon to exit the case and run back to the display.

I designed this in 5 pieces to allow for customization for any spec