Thingiverse
Ender 5 Extruder Arm
par IamSLy
2.4k
Téléchargements
1.1k
Likes
30
Makes
Creality Ender 5 extruder arm.
Device used to reposition the extruder so that the Bowden tube can be drastically shortened.
+ Shorter Bowden tube = less retraction needed = less stringing.
+ Easier access to the extruder itself.
+ Flat top for your own enclosure design. (*)
(*) If you build an enclosure, the way the cable moves in a flat plane will allow you to reduce the height of your enclosure top.
The device is held to the printer with the original extruder attaches.
The extruder is attached to the device using 2 wood type screws with flat heads:
- Screw diameter min 3.0 mm, max 4.5 mm.
Note: You might need a stepper motor extension cable depending on the length of your original cable that was cut in factory. Length on mine was just enough but some users reported that theirs was a bit too short...
Note 2: Cooling of the extruder motor is less efficient than the original position which benefits from some cooling via the aluminium frame. Therefore, consider
Device used to reposition the extruder so that the Bowden tube can be drastically shortened.
+ Shorter Bowden tube = less retraction needed = less stringing.
+ Easier access to the extruder itself.
+ Flat top for your own enclosure design. (*)
(*) If you build an enclosure, the way the cable moves in a flat plane will allow you to reduce the height of your enclosure top.
The device is held to the printer with the original extruder attaches.
The extruder is attached to the device using 2 wood type screws with flat heads:
- Screw diameter min 3.0 mm, max 4.5 mm.
Note: You might need a stepper motor extension cable depending on the length of your original cable that was cut in factory. Length on mine was just enough but some users reported that theirs was a bit too short...
Note 2: Cooling of the extruder motor is less efficient than the original position which benefits from some cooling via the aluminium frame. Therefore, consider
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
