Thingiverse
Ender 5 Extruder Cable Guide
por j0s3m4_7
11
Descargas
4
Likes
0
Makes
The sloppy cable in Ender 5 usually get stuck in the Y motor when locating the extruder system in vertical position. To avoid this issue I was looking for a support but I didn't find anything so I decided to design my own version.
You'll need the 2 screws of the spool holder or similar to anchor the support to the V-slot bar.
If that case you could also find useful this creation:
https://www.thingiverse.com/thing:4339556
Hope you enjoy both things!
You'll need the 2 screws of the spool holder or similar to anchor the support to the V-slot bar.
If that case you could also find useful this creation:
https://www.thingiverse.com/thing:4339556
Hope you enjoy both things!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
