Thingiverse

Ender 5 LED strip holders

by dbltrbl023

1.2k Downloads

699 Likes

4 Makes

Go to Model

A pair of holders for 30cm LED strips (10mm wide)
One for the front with 10 degree angle down, and the one in the back has a 66 degree angle so it doesn´t shine straight in your face.

They are both split in two parts which snap together with some glue. (Couldn´t fit them on the printbed)

Mount with T-nuts and short M3 screws

Print the front holders with support and the back without

Edit: I noticed that my Front LED holder was getting a little bent, not being 100% straight in the joint. Therefore I made a small add-on. A third mount that fits perfectly in the center.

IF this happens to you as well, there´s no need to re-print, just add this small piece ("xtraholder.stl")

Creality Ender 5 Ender-5 Ender5 ender 5 LED led strip ledstrip Led Holder LED light light Creality Ender 5 Ender-5 Ender5 ender 5 LED led strip ledstrip Led Holder LED light light

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Why?

supports needed · significant post-processing

Single piece Supports required Hardware needed

Supports 2/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 2/3

Printer