Ender 5 Plus Cable Management

Cable management for the E5+. Only requires the extension of one set of wires on the X axis stepper motor and end stop.

SOME THINGS TO REMEMBER....

> It's best to look through the "ASSEMBLY GUIDE AND PARTS LIST" first. It's a pdf at the bottom of the list but has most notes and references you'll need.

> 2020 wire covers will need to be resized, print the smallest one till you get it to fit your printer, 97% worked for me.

> Some of these parts use the screw to cut the threads. The 3mm screws do well. But you may need to purchase a #51 drill from Amazon to bore the 2mm screw holes to size. The bit is only about $7

> You will need at least 60 cable chain links and link covers from "jonniewhiskey"s page. BUT you will need one "cable chain dual male end" to attach the Y AXIS REAR DRAG CHAIN BRKT to the rest of the chain

> Some glue is required, Gorilla Super Glue Jell worked well for me

> You will need "Ender_5_Plus_-_Bed_Strain_Releif_Bracket_Arm2" from
"alpokemon"