Ender 5 plus - Case

Housing for an Ender 5 plus.

Printed components were printed in NiceABS, the following are still required:

Acrylic sheets: 2EA 555x400x3mm; 2EA 510x420x3mm; 2EA 637x200x3mm; 2EA 658x200x3mm; 1EA 661x640x5mm

Self-tapping screws 2,9x6,5mm, washers, magnetic tape 20mm x 1m, slot nuts + M4 screws.

The holders for the lid are attached with a slot nut.
I screwed the rear rear wall tightly with the slot nuts, so that the plate fits flush, you need the adapter for the extruder motor, so that it folds inwards by 90 °, I removed the nonsensical filament sensor, it is enough for the cable to draw, no other adjustments are necessary.
I attached the front and the two side walls with the magnetic adhesive tape, so they are easily removable.
The front place of the lid is only pushed in, so you can get good access to the upper installation space.
2x "Ecke-oben" and 2x "V2-Ecke-oben" are required if the front screen should be removable, if not, then 4x "Ecke-oben".
the component "V2-Ec