Thingiverse
Ender 5 Plus Controller Case Fan Bracket
by BlankMan
5
Downloads
3
Likes
0
Makes
This is a bracket for the Ender 5 Plus controller case to move the cooling fan from the bottom to the rear of the controller case and cover the fan's old hole. The air will now be pulled in the front sides and exhausted out the back.
The bracket can accommodate up to three 40mm fans and requires no cutting or drilling of the case to mount it. The bracket and fan mounting holes are sized to accept an M3-0.5 tap. The bracket has a plenum in it so the air is not only trying to be push out through the slots directly in front of a fan, it utilizes all slots.
The bracket can accommodate up to three 40mm fans and requires no cutting or drilling of the case to mount it. The bracket and fan mounting holes are sized to accept an M3-0.5 tap. The bracket has a plenum in it so the air is not only trying to be push out through the slots directly in front of a fan, it utilizes all slots.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
