Ender 5 Plus hotend cable guide (inside the frame)
por fpikus
46
Descargas
19
Likes
1
Makes
I wanted to route the hotend cable inside the Ender 5+ frame (on the same side as the PTFE) but the original guide is a bit too long for this position, protrudes too far toward the bed. The only change is I shortened it.
This one is printed on the same Ender 5+ in PETG, it's more flexible than PLA so easier to clip to the frame.
This one is printed on the same Ender 5+ in PETG, it's more flexible than PLA so easier to clip to the frame.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
