Thingiverse
Ender 5 Plus Hotend cable guide
von BSmotorsport
2
Downloads
1
Likes
0
Makes
quick and easy guide for the ender 5 plus hotend loom. Needs 2x 3mm T-nuts to mount to the back rail.
I used PETG but I'm sure PLA would be fine. Just make sure the hole is smoothed out (some nibs from z-seam might want rubbing down) so the harness doesn't snag and moves freely.
*** one side has radiused edges to look nice, print with that face pointing up ***
I used PETG but I'm sure PLA would be fine. Just make sure the hole is smoothed out (some nibs from z-seam might want rubbing down) so the harness doesn't snag and moves freely.
*** one side has radiused edges to look nice, print with that face pointing up ***
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
