Thingiverse
Ender 5 Pro Control Shroud
311
Downloads
114
Likes
1
Makes
Based on the amazing kilroy01 Control Panel Back Cover.
Just added some fancy venting holes and the Creality Logo.
To avoid the light bleeding I suggest to add some electrical tape in the back of the logo.
EDIT:
In the V2 was added track, a small tray (got from dbltrbl023) and I made the bezel flat.
There is a bonus file with a cutout I used to install my LED illumination switch.
Just added some fancy venting holes and the Creality Logo.
To avoid the light bleeding I suggest to add some electrical tape in the back of the logo.
EDIT:
In the V2 was added track, a small tray (got from dbltrbl023) and I made the bezel flat.
There is a bonus file with a cutout I used to install my LED illumination switch.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
