Thingiverse
Ender 5 pro direct drive guide
por Pat27800
1
Descargas
2
Likes
0
Makes
This small device is attached to the outlet of the extruder and guide properly the wire for filaments change without dismantling every thing.
this is updated : the device is longer and have a tube that is inserted in the extruder to guide the filament soon to the radiator above the heating chamber
Before the installation verify that:
the filament move smoothly inside the piece
the bowden can enter by 5 mm inside the piece
the piece can be installed under the extruder and the tube is not broken during the test
installation have to start by the bottom
this is updated : the device is longer and have a tube that is inserted in the extruder to guide the filament soon to the radiator above the heating chamber
Before the installation verify that:
the filament move smoothly inside the piece
the bowden can enter by 5 mm inside the piece
the piece can be installed under the extruder and the tube is not broken during the test
installation have to start by the bottom
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!