Slicer Discord
Ender 5 Pro Electronics Mod 75x75mm Corner Brackets – 3D-Druckmodell von Thingiverse Thingiverse

Ender 5 Pro Electronics Mod 75x75mm Corner Brackets

von tcosta
28 Downloads
14 Likes
0 Makes
Zum Modell
I recently relocated the electronics box on my Ender 5 Pro to the read of the machine. When I removed it, I noticed that the box was providing a lot of structural support to the frame. So, to help add some support back in, I modified eb3d_printing's 90 Degree Bracket for 2020 to perfectly align with the pre-drilled holes in the frame that were used to attach the electronics box. Bolting it through the frame like this should be stronger than using t-nuts.

To attach the bracket, used two M5x25 bolts along with two washers and a nut. I managed to get the washer and nut to fit into the pre-drilled hole on the outside of the frame for a cleaner look. The M5x25 bolts are the perfect length and don't poke out from the frame.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
75 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

tcosta veröffentlicht auch auf

11 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen