Ender 5 Pro/Plus Zero G enclosure

An enclosure for the Ender 5 pro/plus after doing the ZeroG Mercury one.1 mod.

Say that you have used this enclosure for your stock Ender 5 pro/plus: https://www.thingiverse.com/thing:4787231
And now you have some very nice plexiglas panels.

After doing the ZeroG Mercury one.1 mod this enclosure does not fit any longer because of the location of the drive motors, tension towers.

This enclosure re-uses the same dimension plexiglas plates in such a way that you don't need to re-order or cut them.
That's why I've listed these as a remix, although I've designed the parts from scratch.

I recommend printing in something a little more temperature resistant than PLA, but PLA has worked for me so far.
Layer size .2 - .32
Print on the ~45 degree cut out side.
Symmetrical design, print each one twice for all four corners of the machine.
No supports are needed.

I was only able to verify fitment on my Ender 5 plus, but I don't see any reason why this won't work on an Ender 5 or pro

Note tha