Ender 5 Raspberry Pi case for Octopi

I designed this case for the Raspberry Pi 4 B to mount to an Ender 5. It connects to the back 2020 rail using T nuts, and has an arm to use the Raspberry Pi camera (V1 or V2). I've included mounts for LED lights (link below) and included pictures showing with and without extra lights. The LED mounts slide on the ends of the 2020 rails.

The case and lid snap together. The snap fittings make it a tight fit, but in doing so it makes the ports easier to access, and you only have to install it once.

The camera arm screws into the cable guide and has a ball joint to the camera case that allows you to position the camera exactly where you want it. The arm is threaded with 6mm threads. I found it easier to just use a tap and die set to clean out the threads rather than constantly trying to tweak the printer for the prefect settings. The ball just pops in to the camera body. and the case lid snaps together holding the camera secure.

The majority of pieces are self explanatory to print,