Ender 5 screen case

Made this for myself, got tired of standing up to see the screen (my printer sits up on a shelf at eye level).

The screen tilts back to the original position of the Ender 5, but also goes upright.

Watch out for the ribbon cable length, mine was just about long enough, yours may be different.

Print with 20% infill and 3 layers top, 3 layers bottom.
Print first layer 10 degrees higher than normal to get a good surface finish.
Printed on Ender 5 from factory, no mods needed.

Bolts for hinge are M3 40mm.