Thingiverse
Ender 5 Spool Holder
von Caj109
8
Downloads
5
Likes
0
Makes
I need to print a new spool holder due to some filament I had didn't fit on the original Ender 5 Holder due to the lip it has at the end.
So i measured the original including the slot for the tightening nut and printed it out without the lip. yes I could of cut the lip off but wheres the fun in that!
I printed in the orientation of the slotted end on the build plate
I printed with standard supports in Cura, when I didn't there was a lot of dropped lines in the slots.
So i measured the original including the slot for the tightening nut and printed it out without the lip. yes I could of cut the lip off but wheres the fun in that!
I printed in the orientation of the slotted end on the build plate
I printed with standard supports in Cura, when I didn't there was a lot of dropped lines in the slots.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
