Ender 5 StealthBurner Direct Drive Mod

DISCLAIMER: This design is a little finicky and a tiny bit jank, but it works. Installation is tricky due to the compact nature of the design and some light post processing may be required for a proper fit depending on tolerances.

This is a StealthBurner adaptation for a (mostly) stock Ender 5 based on SpaceCadet_77's Micro Swiss StealthBurner adaptation. It is designed to fit the stock carriage plate with a MK8 hotend and CR Touch mount and uses the stock extruder and stepper motor. The Micro Swiss all metal hotend is also compatible with this design.

Additional required parts:

5015 blower fan
Extended stepper motor cable
2x M4x10 bolts
2x M3x30 bolts
4x M3x12 bolts
3x M3x8 bolts
1x M3 nut

A filament relocation solution is also required for direct drive.

All parts aside from fan mount were printed with ASA using Voron's settings. Fan mount was printed in PLA. Supports at least touching build plate are required and full supports may be useful for some parts dependi