Ender 5 Y-Axis Drive Support Bracket

Perfectly aligns and supports the shaft drive on the Y axis. Without this there was no way for me to be sure it was aligned perfectly. Also puts a bearing on the other side of each pulley. Use 2 minimum, or 4 if you want to be a little crazy and play with getting stepper aligned perfectly. I replaced the coupler and also drilled out the stepper mounting holes so I could let this all self-align with 4x of these brackets. Will need 2 M5x10 SHCS and a 2 t-nuts each. Uses the same F688 bearing as the OEM brackets. Tight fit if your printer is tuned. I printed .2mm layer, 50% infill.