Ender-5 Z-Axis offset changer

I wanted to work alternate with the magnetic or with a glass build plate.
This spacer helps to reduce the level work.

This small spacer can screwed onto the spacer-screw of the ender 5 if changing to a thicker glass build plate.

To avoid loosing this small thingi, i added a tab to hang it on the screw if not used.

It should be customizable, but the customizer works not for me, so i could not test it.

IMPORTANT: Never make autohome with installed glas plate!
I think cracking glass would not sounds very well ;)

I attached two stl-files with following build parameters:
- 7mm screw height
- 0.95mm magnetic plate height
- 3mm glass plate height

The one with 1mm extended top knob can be used to fine adjust with sandpaper or a fine file.

Printing:
Its possible to print it without support, but the height seems more exact if it is printed with support.
Therefore you should use preferably less support, its a little tricky to remove it.
Use a driller to remove the sup