Ender 6 Cable Conduit Brackets

Ender 6 - Cable Conduit Brackets

The provided brackets that hold the cable conduit in place are too small and crimp the conduit when attempting to put them in place.

To overcome this, I looked at other designs; unfortunately, they did not meet my need. As a result, I attempted to design my own. After 2 different design approaches, I settled on this one and it has worked well for my build.

Some thoughts that went into the design:
* Center of mass, I initially did not design a bracket with this in mind and found that it may have led to some unwanted artifacts. I did not test this enough to be sure of the assumption.
* Position of Bowden tube guide directly above the Bowden connector. Initially, I had this slightly off center and the filament jammed a lot easier.
* Hanging the bracket over the metal frame for additional ease of positioning and reducing any play.
* Use the same bolt/fastener positioning as the original brackets, as well as the same bolts/fasteners.
* Add a li