Thingiverse
Ender 6 - Cable Mount Thing
par SmplMakr
69
Téléchargements
34
Likes
2
Makes
I wanted something that looked nice to hold the filament tube and the cable thing in position so it wasn't freely moving around.
All the other options I found on here would put the filament tube in front of the cable tube, which causes a slight bending the filament tube. I didn't want to chance that bend having any sort of impact on the retraction of filament, so I opted to make something that centers the filament tube, and places the cable tube to the side.
It's probably not the best, still learning Fusion360, but it works, at least for me :)
Thought I would share, incase someone else wanted it too.
Its kinda a tight fit. The filament tube does fit, but you gotta give it a little baby push to get it into its hole. and when you tighten it down, it should work just fine.
I used two M3x20 Hex Screw Head Cap Bolts
All the other options I found on here would put the filament tube in front of the cable tube, which causes a slight bending the filament tube. I didn't want to chance that bend having any sort of impact on the retraction of filament, so I opted to make something that centers the filament tube, and places the cable tube to the side.
It's probably not the best, still learning Fusion360, but it works, at least for me :)
Thought I would share, incase someone else wanted it too.
Its kinda a tight fit. The filament tube does fit, but you gotta give it a little baby push to get it into its hole. and when you tighten it down, it should work just fine.
I used two M3x20 Hex Screw Head Cap Bolts
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !