Ender 6 Octopus Board Base

This is a base for the Octopus V1.1 to fit in the default location for the Ender 6. Beware that I was not able to get this to fit in the default location on the Ender 6 due to the Heatsinks on the Octopus board being too high. I was not willing to compromise with spacing needed for grounding and other requirements and abandoned the project. The pictures reflect mocking up the board and the underside of the printer as I went through the process of trying to get it to fit. Along the edges of the printer you can see the standoffs and the weather stripping to allow clearances.

In addition the model has some M3 heat sinks added. as well a bit of filing will be required to open the holes on the default Creality location pins. I wanted a good fit. And the model could us a tweak as one standoff wall is a bit thin but that did not affect its use overall.