ender 6 tablet mounting kit

This is a bracket mounted tablet holder for people running klipperscreen or using klipper through the rpi ip adress.I am using a samsung tab a 2017 (8inch) display. This is easily changed by converting a mesh in fusion to edit for the tablet of your choice, as long as it is no bigger then 8 inches. You could use the bracket and make your own cradle and facia if you are using something bigger.

All that is needed to convert you e6 is remove old lcd screen and front bracket, drill 2 holes (3mm) in base plate (41mm) from front edge. Use the bracket as a template to decide the placement. you will also need to cut the doors to size. On each door from the base measure upwards 102mm and from the inside edge where the doors meet together 118mm and cut using tool of your liking. I used painters tape to mask along sharpie line to help guide my circular saw. you may need to clean up edge of aclylic door with sand paper or heat gun, this is up to you. Run the power cord for tablet through exist