Thingiverse
Ender Cr Touch Light Shield
por Extrusions
0
Descargas
3
Likes
0
Makes
Steps for installation:
Step1: Remove the hot end cover (2 Screws) and remove the two screws mounting the Cr-touch.
Step2:Remove the Steel mount (2 Screws) and the Cr-touch cable.
Step3: Slot in the CR-Touch from the bottom and leave some space in-between the 3d printed end and the Cr-Touch.
Step4: Now slot in the mount through the given Cutout and tighten the Cr-touch with the bracket.
Step5:Replace the bracket with the head and close it with the hot end cover and connect the Wire.
Step1: Remove the hot end cover (2 Screws) and remove the two screws mounting the Cr-touch.
Step2:Remove the Steel mount (2 Screws) and the Cr-touch cable.
Step3: Slot in the CR-Touch from the bottom and leave some space in-between the 3d printed end and the Cr-Touch.
Step4: Now slot in the mount through the given Cutout and tighten the Cr-touch with the bracket.
Step5:Replace the bracket with the head and close it with the hot end cover and connect the Wire.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
